User Manual

Sensus In-Line Zigbee Module – User Manual
4
2.0 Installation of the module within an electric meter
First remove the meter outer cover.
Carefully remove the meter inner cover.
Disconnect the ribbon cable from the sensor pcb.
Insert the Zigbee board into the connector that the display ribbon has been
disconnected from.
Insert the free end of the ribbon cable into the connector on the Zigbee module
as shown in Figure 1.
Add the jumper (short) to position J202 on the sensor board, as shown in Figure
2.
Figure 1 – Zigbee module installed in a meter