User's Manual

12
To be used only for the purpose for which it is submitted. All rights reserved to AMDS LLC. Reproduction without written
consent is prohibited.
AMDS CONFIDENTIAL
the FCC Rules. Highly controlled and specialized software, protected using
password login is utilized (either through a specialized diagnostic port or via a
secure internet link to the TGB) by ONLY AMDS authorized personnel, to
program any of the on-air operational parameters of the TGB.
3.2. Starting and Stopping
Prior to powering down the TGB Electronics, the Halt command should be
issued to the Fusion Processor via the internet link or by qualified AMDS
service personnel. After the Fusion Processor has completed shutdown, the
TGB Electronics can then be powered-down by switching the Chassis
breaker/disconnect to the OFF position. To start the TGB Electronics simply
switch the Chassis breaker/disconnect to the ON position.
If a qualified AMDS service professional is not present to execute the Halt
command to the Fusion Processor, the unit may be powered off (and then on
if desired) by the operator with no detriment to the system or it’s operation. If
this scenario is performed by the operator it is the operator’s responsibility to
inform the AMDS network operations center of this condition so that AMDS
personnel can perform the appropriate housekeeping for the TGB via the
secure internet link.