User's Manual

consent is prohibited.

AMDS CONFIDENTIAL

2.2.2. Power/Battery

!!! Warning !!!

Do not make any connections with power applied to the system. The

batteries are a source of energy and can be hazardous if shorted.

Exercise caution.

Prior to connecting batteries, disconnect the battery cable from the right

hand side of the rectifier cabinet. Install batteries and connect jumpers to

battery terminals. Before reconnecting battery cable to right hand side of

rectifier cabinet, measure open circuit voltage between pins 1 & 2. The

voltage should be above 24VDC. If the voltage is below 22VDC, do not

proceed with connection—batteries must first be charged before

installation.

2.2.3. Antenna

The antenna connection is a Type-N female located on the top of the

indoor cabinet (bottom of the outdoor cabinet). The connector is a

bulkhead mounted surge arrestor rated at 90V.

The antennas (and their installations, including separation distances)

utilized by the TGB must follow the following FCC guidelines:

For Part 24:

The antenna(s) used for this transmitter (receiver) must be fixed-mounted

on outdoor permanent structures. RF exposure compliance is addressed

at the time of licensing, as required by the responsible FCC Bureau(s),

including antenna co-location requirements of §1.1307(b)(3).

For Part 90 and Part 101 Operation:

The antenna(s) used for this transmitter must be fixed-mounted on

outdoor permanent structures with a separation distance of 2.5 meters for

the HP model and 0.5 meters for the LP model (Note: Model numbers are

ascertained by either front panel labeling or by noting the IC or FCC ID

label placed on the rear panel of the TGB) from all persons during normal

operation. The peak conducted output power at each antenna terminal

must not exceed 1.24 Watts for the LP model and 32.21 Watts for the HP

Model. The peak radiated output power (EIRP) must not exceed 16.14

Watts for the LP model and 418.8 Watts for the HP model.