User's Manual

AMR Transmitter Mounting Instructions for American Meter
AL800, AL1000, AL1400, AL2300, AL5000, 80B, 250B, 500B
6
Assemble index and cover onto
transmitter
Place the index and index cover on the Transmitter onto the gas meter, aligning
the index shaft to the Transmitter’s shaft
1. Attach the Transmitter to the meter using the four (4) mounting screws with
#3 Phillips screwdriver. Place all screws, then torque down two (2) diagonal
screws. Check shaft alignment again, then tighten the last two (2) screws.
2. Should two (2) or more screws shear or strip during the installation, the
meter will need to be replaced by a qualified utility representative. Remove
the transmitter and reinstall the index and index cover on the meter with the
original screws. Enter the appropriate information in the Mint HHT and skip
to the next work order.
3. Install the two snap seals in the index cover and insert fully with the aid of a
¼” nut driver. Align the end of the nut driver on the snap seal and tap the
end of the nut driver handle with your hand until it is fully seated.