User's Manual

AMR Transmitter Mounting Instructions for Invensys (Equimeter, Rockwell)

models R750, R800

Mount Transmitter and cover on meter

Verify that the transmitter is functional: check that the magnet on the bottom cam

is visible; with the HHT check the transmitter ID and validate with the

transmitter label.

Prepare the index cover within reach. This should be (replace if necessary) a

plastic index cover with bosses for snap seals, as shown in this document.

Place the AMR Transmitter+index onto the gas meter. Adjust the

Transmitter shaft’s position by holding it from the top, and combine it

into the meter’s fork shaped drive dog. Rotate the shaft from the top and

verify there is a slight freedom of motion.

While holding the Transmitter in place, place the index cover properly on

the Transmitter, so that the index cover screw bosses align with the holes

in the Transmitter.

Insert the two mounting screws through the cover and the Transmitter,

and fasten securely to the meter.