User's Manual

AMR Transmitter Mounting Instructions for Schlumberger/Sprague

models S175, S240, S250, MET250, S400 with slant interface

Install the index cover supplied (it only fits in one direction – the bump

fits in the right side of the Transmitter). Check that the gasket is properly

aligned and fasten to the Transmitter with the four (4) index cover

screws.

CAUTION

Use care when working with a

power screwdriver to insert screws

in the plastic Transmitter box. Over

tightening will damage the box

and/or weaken the contact.

Install the two snap seals in the index cover and insert fully with the aid

of a ¼” nut driver. Align the end of the nut driver on the snap seal and

tap the end of the nut driver handle with your hand until it is fully seated.