User's Manual

AMR Transmitter Mounting Instructions for Invensys (Equimeter, Rockwell)

models R175, R200, R250, R275, R310, R315, R415

While holding the index in its position, insert the right screw further in,

so that the gear wheels remain combined. Verify slight freedom of

motion and then insert and tighten the left index screw.

While the index is still a bit loose, centralize its position. Check that the

motion is smoothly transferred and there is no binding between the shaft

and wriggler, by gently rotating back and forth the index’s proving hand.

Tighten the index screws, securing the index to the Transmitter.

Install the index cover supplied (it only fits in one direction – the bump

fits in the right side of the Transmitter). Check that the gasket is properly

aligned and fasten to the Transmitter with the four (4) index cover

screws.

CAUTION

Use care when working with a

power screwdriver to insert screws

in the plastic Transmitter box. Over

tightening will damage the box

and/or weaken the contact.