User's Manual

Transmitter Mounting Instructions

FlexNet 100G-FL, 200G-FL and 300G-FL

See the appendix for descriptions of the screw kits and tools required for mounting the AMR transmitters.

Remove Index Cover

1. Use a small, flat screwdriver to punch out the snap seals covering the index cover screws.

NOTE:

If two (2) or more screws shear off during the cover removal (or were previously sheared off), the meter will need to be replaced by

a qualified utility representative. Reinstall any index cover screws that were removed and cap with seals if possible. Enter the

appropriate information in the Mint HHT

2. Remove the index cover screws.

3. Remove the index cover.

Remove Index

1. Remove the screws securing the index to the meter.

2. Carefully, remove the index from the meter.

3. Remove any debris from the index.

4. Inspect the index for proper operation by turning the input shaft and verifying that the gears turn freely.

5. Inspect the index for any missing or broken hands.

6. Use a putty knife to scrape away any remaining gasket material.

Mount Transmitter

1. Align the transmitter’s shaft with the gas meter’s male/female wriggler.

2. Place the AMR Transmitter on the gas meter.

3. Adjust the transmitter shaft’s position

4. Ensure the shafts are aligned by holding the transmitter in place and gently rotating the transmitter’s

shaft with your other hand.

5. Loosely attach the transmitter to the meter using the transmitter mounting screws

6. Check shaft alignment.

NOTE:

If two (2) or more screws shear off during the cover installation, the meter will need to be replaced by a qualified utility

representative. Reinstall any index cover screws that were removed and cap with seals if possible. Notify the utility of the

condition of the meter in accordance with your company policy.

7. Tighten the transmitter mounting screws.

Replace Index and Install New Index Cover

1. Loosely attach the index to the transmitter using the index screws.

2. Align the index’s male/female wriggler with the transmitter’s shaft, and adjust as needed.

3. Center the index in the transmitter, and ensure there is no binding between the shaft and the wriggler.

4. Secure the index screws.

5. Install the new index cover.

6. Align the gasket with the transmitter.