Quick Guide
EQG-10010-01
FlexNet® SmartPoint® Module for Aclara kV2c
Warnings & Hazards
Warning
Sensus devices are for professional installation only. They
are to be serviced by professional personnel only. This
product is NOT for consumer installation or servicing.
Warning
The antenna used for this transmitter must not be co-
located in conjunction with any other antenna or trans-
mitter.
ATTENTION
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and
receiver
• Connect the equipment into an outlet on a circuit
different form that to which the receiver is connected
• Consult the dealer or an experienced radio/TV tech-
nician for help
Warning
If you are not sure of the rated power of your radio,
contact your Sensus representative or dealer and supply
the product model number found on the product label. If
you cannot determine the rated power out, then assure
3-feet separation from the body to the device.
Warning
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT
REMOVE COVER (OR BACK). NO USER SERVICEABLE
PARTS INSIDE. REFER TO QUALIFIED SERVICE PER-
SONNEL.
RADIATION HAZARD
In order to satisfy the FCC RF exposure limit for transmit-
ting devices, a separation distance of 20cm (7.9 inches)
or more should be maintained while operating the
Sensus FLEXKV2C. To ensure compliance, operation at
closer than this distance is not recommended. This mini-
mum safe distance is required between personnel and
the antenna of this device.
RADIATION HAZARD
In order to satisfy the ISED RF exposure limit for trans-
mitting devices, a separation distance of 20cm (7.9
inches) or more should be maintained while operating
the Sensus FLEXKV2C. To ensure compliance, operation
at closer than this distance is not recommended. This
minimum safe distance is required between personnel
and the antenna of this device.
An de satisfaire à la limite d’exposition RF pour les ap-
pareils de transmission, une distance de séparation de
20cm (7.9 pouces) ou plus doit être maintenu pendant
le fonctionnement du Sensus FLEXKV2C. Pour assurer
la conformité, un fonctionnement à distance inférieure à
celle est pas recommandée. Cette distance minimale de
sécurité est nécessaire entre le personnel et l’antenne de
cet appareil.
ATTENTION
Any modications made to this device that are not ap-
proved by Sensus may void the authority granted to the
user by the FCC to operate equipment.
ATTENTION
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interfer-
ence, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouil-
lage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.