User Manual

2. Connect to the ToughPad or a Windows equipped laptop via the USB cable or
Bluetooth.
• If connecting via a USB cable, you will need to check the version of Windows. If you
are running an earlier version than Windows 7, you will not have the appropriate
drivers and will need to download a virtual COM port (VCP) driver first. (Available at
http://www.ftdichip.com/Drivers/VCP.htm).
• If connecting via Bluetooth, you will need to pair the FlexNet EasyLink Reader the
first time it is connected. See Bluetooth Pairing on page 9.
3. Power on the ToughPad/laptop and the FlexNet EasyLink Reader.
4. If using the ToughPad, launch the FlexNet EasyLink WorkBook Application which is pre-
installed. If using a laptop, you will need to download and install the FlexNet EasyLink
WorkBook Application.
5. Open the EasyLink WorkBook application and login. If this is the first time you have
logged in to the application you will need to follow the Initial Login on page 8 steps
and you may need to create a new password.
Initial Login
If this is the first time you are logging in to the FlexNet EasyLink WorkBook Application, you
will need to follow a few additional steps.
1. From the main screen of your ToughPad or laptop, open the EasyLink WorkBook
application.
2. Click the settings button on the bottom right of the screen (the gear icon).
3. Click the SSL checkbox.
4. Click the Update button and wait for it to state "server updated successfully." If you do
not get a success message, make sure that you have an active internet connection and
that there are no firewall restrictions in your network preventing access.
5. Fill in all the fields.
Enter your username and password.
Click Groups and select EasyLink.
Click Profiles and select your company environment name.
2 Setup the FlexNet EasyLink Reader | 8
DRAFT 8