User Manual

2 Setup the FlexNet EasyLink
Reader
The FlexNet EasyLink Reader and its' accessories are designed for using in a moving
vehicle. Please follow all local safety regulations when operating a moving vehicle.
1. Place the FlexNet EasyLink Reader in a secure location inside the vehicle. A side strap
is provided on the EasyLink Reader to carry the unit to the vehicle or use one the
provided nylon strap(s) as a shoulder strap.
2. Secure the FlexNet EasyLink Reader so that it will not move around or shift while the
vehicle is moving. You may choose to run the provided straps through the D rings to
secure the unit to a seat if another secure mounting method is not readily available.
Note: If placing the unit in the passenger seat, it may be necessary to use the seatbelt or disable
the airbag, depending on the type of vehicle.
Note: If mounting the unit using a third party mounting kit, follow all safety regulations and
instructions for your particular mounting unit.
CAUTION: Do not block the cooling vents of the FlexNet EasyLink Reader. The intake
cooling vents are located on the front of the unit. The exhaust cooling vents are located
on thetop of the back side and the back end of the top of the unit.
3. Secure the antennas to the top of the vehicle in the center of the roof. If you are using
both antennas, place both as close to the center of the roof as possible.
The FlexNet antenna sends FlexNet NA2W wake up tones, FlexNet electric drive-
by commands, and receives all FlexNet messages and ERT Standard Consumption
messages. The ERT antenna sends the ERT Interrogation tone for wake-up ERT
devices. The FlexNet antenna is the only antenna you need unless you have wake-up
ERT devices.
4. Run the antenna cables between the door and body of the vehicle and connect them to
the EasyLink Reader.
2 Setup the FlexNet EasyLink Reader | 6
DRAFT 8