User Manual

Compliance Statements
Warning: Sensus devices are for professional installation only. They are to be serviced by
professional personnel only. This product is NOT for consumer installation or servicing.
RF Radiation Hazard: In order to satisfy the FCC RF exposure limit for transmitting devices,
a separation distance of 100 cm (39.37 inches) or more should be maintained while operating
the Sensus FlexNet EasyLink Reader. To ensure compliance, operation at closer than this
distance is not recommended. This minimum safe distance is required between personnel and
this antenna of this device.
RF Radiation Hazard: In order to satisfy the ISED RF exposure limit for transmitting devices,
a separation distance of 100 cm (39.37 inches) or more should be maintained while operating
the Sensus FlexNet EasyLink Reader. To ensure compliance, operation at closer than this
distance is not recommended. This minimum safe distance is required between personnel and
this antenna of this device.
Afin de satisfaire à la limite d'exposition RF pour les appareils de transmission, une
distance de séparation de 100 cm (39.37 pouces) ou plus doit être maintenu pendant le
fonctionnement du Sensus appareil. Pour assurer la conformité, un fonctionnement à distance
inférieure à celle est pas recommandée. Cette distance minimale de sécurité est nécessaire
entre le personnel et l'antenne de cet appareil.
Warning: The antenna used for this transmitter must not be co-located in conjunction with
any other antenna or transmitter.
Shock Warning: Transmit only when people outside the vehicle are at least the
recommended minimum lateral distance away from the body of a vehicle with a properly
installed antenna. This separation distance will ensure that there is sufficient distance from a
properly installed (according to installation instructions) externally-mounted antenna to satisfy
the RF exposure requirements.
Attention: For Class B - Unintentional Radiators:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
Consult the dealer or an experienced radio/TV technician for help
Warning: Any modifications made to this device that are not approved by Sensus may void
the authority granted to the user by the FCC to operate equipment.
Compliance Statements | 11
DRAFT 8