Manualshelf

Installation Guide

ManualsBrandsSensus Metering Systems ManualsElectronicsNetwork Base Station For Metering System
78910111213141516
Sensus BA0031 Assembly & Installation Guide (12.14.04) Page 13 12/14/2004
Device Mode – Base Station
1. Set ‘BS ID’ and ‘BS Tx ID’. The device uses the ‘BS ID’ for identification when
sending or receiving messages in the backbone communication link. The range of
‘BS ID’ is 1 to 65,635. The device uses the ‘BS Tx ID’ when transmitting air
messages. The range of the ‘BS Tx ID’ is 1 to 16,777, 215.
2. Set the device IP parameters. Set ‘BS IP’ and ‘BS Port’ address. The ‘BS MAC
Address’ is configured in the factory.
3. Set the destination IP address. If necessary set a gateway address also.