Installation Guide

Sensus BA0031 Assembly & Installation Guide (12.14.04) Page 10 12/14/2004
Installation
Installation Steps
1. Install the supplied ‘LabVIEW’ Run-Time engine and the configuration program
‘Base II v1.10’ in your PC by following the procedure described in Software
Package Installation.
2. Disassemble the device top cover.
3. Insert the Ethernet backbone communication cable (not supplied, used in Base
Station mode only) and the output cord of the 115VAC to 9VAC transformer
(supplied) via the cable entries and connect them.
4. Plug the transformer to 115VAC source.
5. Use the serial communication cable (supplied) to connect available COM port on
your PC and the device Console Port (RJ45 connector).
6. Configure the device by following the procedure described in Device Configuration
7. Disconnect the serial communication cable and assemble the top cover.
8. Mount the device.
Software Package Installation
1. Insert the supplied CD-ROM. Open the directory ‘LabVIEW Run-Time ’ and
double click on ‘lvrteinstall.exe’. Next, follow the instruction of the installation
program.
2. Create new directory on your PC and copy the file ‘Base II v1.10.exe’ from the
supplied CD-ROM to the new directory.
3. Double click the file to run the program ‘Base II v1.10’.