User's Manual

• ID: FIXNET1 – which means a TouchRead was attempted

on an unsupported meter (Neptune).

• ID: FIXNET2 – which means that the port was configured

for a meter type that supports TouchRead (Sensus only)

but there was no response from the meter.

5.) If unsuccessful detection, the TouchRead will start the activation

process again. The ID on the AutoGun will display FIXNET0 similar to

the step 2 above.

Note: Once the radio is activated and it detected what is connected, the

only way to change its configuration as to what is connected is to

deactivate the radio using a programming tool and re-activate the radio or

use a programming tool to reprogram the port manually.

Warning… Programming a port manually will not allow the unit to perform

an automatic detection on that port unless reset to “AutoDetect”. The

activation process will not reset the port type.