User Manual

Hardware Setup 2-1
UniPro/OMNI Communicator Model 100A WRMTM-40000
2 Hardware Setup
2.1 Attaching the Hardware
1. Attach the USB connector from the OMNI Communicator 100A to any available USB port on your
laptop.
2. Check your Device Manager to determine the USB port’s Com Port designation.
3. Select Start→Control Panel→System→Hardware Tab→Device Manager.
The Device Manager window looks similar to the one shown in Figure 2-1.
Figure 2-1: Typical Device Manager Window
4. Select Ports in the list and note the USB Serial Port COM assignment (COM8 in the illustration).
2.2 Setting the COM Port
1. Double-click on the UniPro icon on your desktop.
The UniPro Program Wizard screen is displayed (see Figure 2-2).