User manual

Sensorsoft Alert User Manual
In the command lines above, ttyS4 is the name used to access serial port 4. The relay can be
connected to any serial port on the back of the Alert appliance. As an example, if the relay was
connected on serial port 8, use ttyS8 in the command line.
5. For each command line alert that you would like to enable, check the corresponding Enable checkbox.
6. Click on the Save Changes button.
7. It is highly recommended that you test all of your commands to ensure that they are properly setup.
You can test each command by clicking on its Test Command Line button.
43