User manual

Sensorsoft Alert User Manual

Figure 17: Configuring Command Line Alerts for a Scalar Variable

In the example shown in Figure 17, above, the Alert appliance will turn ON a relay connected to port

4 when the reading exceeds the Scalar Critical High Limit, and will turn OFF the relay when the

reading returns to normal.

4. In order to turn a relay on, you will need to enter the following command in the Command field:

scom -Q /bin/SR6171_ON.ini ttyS4

In order to turn a relay off, you will need to enter the following in the Command field:

scom -Q /bin/SR6171_OFF.ini ttyS4