User manual
Sensorsoft Alert User Manual
Figure 12: Paging Settings on the Administration Page
3. Select the port where the modem connected.
4. Select the correct modem type.
5. Make sure this port is NOT being monitored, by clearing the Enable Monitoring checkbox in the Port
Settings table located at the top of the page.
6. Click the Save Changes button.
Setting up Pager Alerts for Device Variables
1. Go to the Device Configuration page for the monitored device of interest. To get to this page, first
click on the View Monitor List hyperlink on the left side of the web page. From the View Monitor
List page, click on the Description hyperlink for the monitored device of interest.
2. From the Device Configuration page, click on the Setup Pager Alerts for this variable hyperlink for
the device variable of interest. This will take you to the Pager Setup page of the variable for which to
setup Pager alerts.
3. On the Pager Setup page, you will see the following table in the upper right corner:
Figure 13: Setting pager recipient information on the Paging Alert Configuration page
Enter the modem pool number of the paging service provider in the Modem Pool Number Field.
There should be only one number in this field. Then, enter the recipient pager IDs in the Pager ID
field. Multiple pager IDs must be delimited by commas.
4. If the selected device variable is a scalar variable (e.g. temperature or humidity), you will see the table
shown in Figure 14 on the Pager Setup page.
37