User manual

Sensorsoft Alert User Manual

Figure 11: Configuring Email Alerts for a Scalar Variable

Notice that for a scalar variable, you can configure email alerts to be sent in the following alert states:

 Email on Scalar Critical – The email that will be sent when the variable reading is less than the

scalar critical low limit or greater than the scalar critical high limit.

 Email on Scalar Warning – The email that will be sent when the variable reading is less than the

scalar warning low limit or greater than the scalar warning high limit.

 Email on Return to Normal. – The email that will be sent when the variable reading returns to

normal after breaching any limit.

For a Boolean variable, you can configure email alerts to be sent in the following alert states:

 Email on Boolean Critical – The email that will be sent when the variable reading is in the

Boolean critical state.

 Email on Return to Normal. – The email that will be sent when the variable reading returns from

Boolean critical state to normal state.

4. For each email alert that you would like to enable, check the corresponding Enable checkbox.

5. In each Subject Line field, specify the email subject for the corresponding alert condition. You may

want to use dollar variables (e.g. $L, $R) to bind live information such as the current reading into your

message. This is described in Appendix A.