User manual

Sensorsoft Alert User Manual
Figure 10: SMTP Settings on the Administration Page
You must enter at least one valid SMTP server address to be used for sending emails. When sending
out an Email alert, your Alert appliance will attempt to use the Primary SMTP Server first. If this
attempt fails, it would then try the Secondary SMTP Server. The Sender Address will indicate to the
recipient(s) who the Email is from. Please note that most SMTP servers require the Sender Address to
be a valid email address or else the email will NOT be sent.
3. After these fields are set, click the Save Changes button.
Setting up Email Alerts for Device Variables
1. Go to the Device Configuration page for the monitored device of interest. To get to this page, first
click on the View Monitor List hyperlink on the left side of the web page. From the View Monitor
List page, click on the Description hyperlink for the monitored device of interest.
2. From the Device Configuration page, click on the Setup Email Alerts for this variable hyperlink for
the device variable of interest. This will take you to the Email Setup page of the variable for which to
setup Email alerts.
3. The following table (Figure 11) will come up for scalar variables (e.g. temperature or humidity) on the
Email Configuration page:
34