User manual

Sensorsoft Alert User Manual
Monitor List Auto-Refresh Interval
The Monitor List page (see Figure 6) auto-refreshes at a regular interval to continuously display the latest
sensor readings. This interval can be configured by following the steps below:
1. Login to the Alert web interface as admin.
2. Click on the Administration hyperlink located on the left side of the View Monitor List.
3. In the View Monitor List Display Options table, locate the field Monitor List Refresh Interval and
enter the refresh interval in seconds.
4. Click the Save Changes button at the bottom of the page.
Displaying Device Variables on the View Monitor List
Some Sensorsoft devices and Sensorsoft Plug-in supported devices can have multiple variables. For
instance, the Sensorsoft SS6610J Temperature Humidity Meter has two temperature and two humidity
variables. You can choose which of these variables are displayed on the View Monitor List. You may
decide to display one of the temperature and one of the humidity variables. The following procedure
outlines how to select variables to be displayed on the View Monitor List.
1. Determine which monitored device is of interest.
2. Login to the Sensorsoft Alert Appliance’s web interface as admin. From the View Monitor List, click
the Description hyperlink of the monitored device whose variables you want to add to or remove from
the View Monitor List. You will see the Device Configuration page:
26