User's Manual

Smart Systems User’s Manual Version 1.1

Once all 4 swivel adapters are attached, the Noggin can then be attached to the Smart

Cart.

The Noggin is usually attached to the cart with the long axis of the Noggin unit parallel to

the wheels on the cart (see Figure 2-10 ,Figure 2-11 and Figure 2-12). For this

orientation, make sure the 37 socket female electrical receptacle on the Noggin faces

the back of the cart so that the cable on the cart will reach the receptacle.

It is also possible (but not usual) to attach the Noggin to the cart with the long axis of the

Noggin perpendicular (at right angles) to the wheels on the cart. For this orientation,

make sure the 37 socket female electrical receptacle on the Noggin is on the same side

of the cart as the odometer so that the cable on the cart will reach the receptacle.

Noggin 250: Remove the Clevis pins from the swivel adapters. Now, on the bottom of

the cart, locate the 4 oval, moveable hangers suspended from the frame of the cart (see

Figure 2-6). Notice that each hanger has a hole in it. To attach the Noggin 250 to the

cart, place each hanger into the slot on the top of the swivel adapters, line up the holes

and insert the Clevis pin.

Figure 2-6: Attaching the Noggin 250 to the cart.

Noggin 500 and Noggin 1000: Remove the Clevis pins from the swivel adapters. Now,

on the bottom of the cart, locate the two, flat, moveable crossbars suspended from the

frame of the cart. If the crossbars are attached, go to step B.

Step A: If the crossbars are detached from the cart, they will need to be attached before

attaching the Noggin to the cart (see Figure 2-7 top). To attach the cross bars, use the 4

oval, moveable hangers suspended from the frame of the cart. Insert the hanger into the

slot on the crossbar, line up the holes and insert the Clevis pin.

Step B: Notice that each crossbar has 2 holes, one on each side. To attach the Noggin

500 to the cart, place the crossbars into the slots on the top of the swivel adapters, line

up the holes and insert the Clevis pins.