User's Manual
Conquest DE Transducer Module 2-System Assembly
3
2.1 Connecting up the System
Refer to Figure 2-1.
a) Connect the Transducer Module to the female end of the Transducer Cable.
Figure: 2-2 Connecting the Transducer Cable to the Transducer Module.
b) Connect the male end of the Transducer Cable to the back of the DVL.
c) Connect the Power Cable to the back of the DVL.
d) Connect the 4 pin male end of the to Power Cable to AC Mains cable. When the DVL
is receiving power the upper red LED on the front of the DVL will be illuminated. When
the Transducer Module is receiving power the red and green LEDs will illuminate.
e) Turn the DVL ON by pressing any button on the front. As the DVL boots up, the lower
red light will come on.