Operator`s manual

3-6 SpeedDome Ultra VI Operator's Manual
Manually Activating or Deactivating the IR Mode
The IR mode can be manually activated or deactivated using a combination of keyboard
commands. This allows you to change between color and B/W modes as needed.
· To change the mode using SensorNet or RS-422 protocols: press and hold Iris Open,
press and hold Focus Far, then press Focus Near.
· To change the mode using Manchester protocol: enter 68, and then press Call Preset.
Using the manual command has the following affect on the menu settings:
If the current IR Mode setting is... The setting changes to...
IR Mode On IR Mode Off
IR Mode Off IR Mode On
IR Mode Auto High, Auto Mid, or Auto Low
IR Mode On
Tip: If you need to resume Auto High, Auto Mid, or Auto Low IR mode settings, you
must use the Dome Configuration Menu. See Changing the IR Mode Setting on page 3-5.