Specifications

34 INSTALLATION AND SERVICE GUIDE
SpeedDome Ultra III and IV Camera Dome
s
8000-2573-18, REV.
D
Ordering Parts
This section helps you to identify parts that make
up the base and housing and eyeball assembly.
Parts in Table 3 are shown in Figure 37.
Order parts through your parts distribution network.
Table 3. Parts list
1 Mounting Base 0400-1146-01
2 Video Cable Adapter,
BNC to Micro
Video Cable Adapter,
BNC to Micro (with Ferrite)
6003-0131-01
6003-0170-01
3 Plug, 4-Pin 2109-0572-04
4 Plug, 9-Pin 2109-0572-09
5 Lanyard 0500-8019-01
6 Screw, PH, M3 (Qty. 6) 5801-1051-120
7 Washer, Ext. Tooth, M3 5851-0200-041
8 Clip, Lanyard 0500-8046-01
9 Mounting Base 0500-7257-01
10 Ground Clip 0500-7293-01
11 I/O Board 0301-0546-01
12 Dust Cover 3100-0066-01
13 Screws, M3x8 PHP (Qty. 3) 5801-1071-111
14 Cap 0500-8021-02
15 CPU PC Board 0301-0948-03
16 Fan Cable Assy. 0650-2001-01
17 Standoff, M3x8Hx13L (Qty. 3) 5899-0055-01
18 Fan Plate 0500-8018-01
19 Standoff, M3x6Hx19L (Qty. 3) 5887-1122-020
20 Power Supply PC Board 5606-0015-01
21 Slip Ring Assy. 2100-0005-01
22 Pan Motor 3501-0017-01
23 Housing 0500-7255-02
24 Bearing Assy., Pan Gear 2510-0040-01
25 Skirt 0500-6710-01
26 Tilt Motor 3501-0018-01
27 Slot Cover (No Lens)* 0500-8037-01
28 Yoke, Camera 0500-7258-01
29 Camera/Lens PC Board 0301-0953-01
30 Bearing Assy., Lens Carriage 2510-0038-01
31 Yoke Bracket (Qty. 2) 0500-8038-01
32 Cable Assy., Tilt 0650-1680-01
33 Camera, 12x, NTSC 2003-0037-01
34 Camera, 12x, PAL 2003-0037-02
35 Camera, 12x, EIA 2003-0037-03
36 Camera, 12x, CCIR 2003-0037-04
37 Camera, 16x, NTSC 2003-0037-11
38 Camera, 16x, PAL 2003-0037-12
39 Camera, 16x, EIA 2003-0037-13
40 Camera, 16x, CCIR 2003-0037-14
41 Washer, Flat 2848-8100-07
42 Screw, ¼-20 x 3/8 2802-7407-65
43 Screws, M2x3 (Qty. 4) 5801-0011-120
44 Tripod Mount 0500-6712-01
45 Slot Cover with Lens* 0400-1178-01
* Items 27 and 45 are supplied with the final
assembly, not the eyeball assembly.