Specifications

Chapter 4  Setup 27
Use the buttons to make sure targets are active (circled) where
motion is to be detected. When you finish, press the Function
button to save the target setting and display the next screen.
A motion bar appears at the top center of the motion setup screen
when the multiplexer detects motion. You can see the effect of
your motion settings by watching the motion bar during setup.
When finished with motion setup, press Function to return to
the camera titles menu. Then press Zoom to go to menu 8 or
press Function+Zoom to save all changes and leave the menu
system. (Press Function+Zoom again if necessary.)
Menu 8  Security Lock
Menu 8 controls the multiplexer front panel security lock feature.
When this feature is on, the multiplexer locks all front panel
buttons except those required to re-enter the setup mode. Press
the up or down arrow button to change this option. The new
security lock setting takes effect when you exit the setup system.
When you finish, press the Zoom button or Function+Zoom to
save all changes and leave the setup system.