Specifications

Chapter 4  Setup 21
Pass-Thru Extrnl Alrms
This option reduces the shakiness and jitter associated with high
resolution compressed multicamera images.
ON  Uses the special filtering circuit when the multiplexer
displays a multicamera image on the main monitor.
OFF  Turns off the special filtering circuit.
The default IMAGE TENDERIZER setting is ON.
When finished, press the Zoom button to go to menu 4 or press
Function+Zoom to save all changes and leave the setup system.
Menu 4  VCR Record Time
Menu 4 allows you to enter the VCRs normal and alarm record-
ing speeds. With autodetect VCR speed, these settings are used if
that signal is lost. Use the up and down arrow buttons to set
each speed as follows:
VCR RECORD TIME  The VCRs normal (nonalarm)
operating speed (2999 hours).
The default VCR RECORD TIME is 024 HRS.
VCR ALARM RECORD TIME  The VCRs recording speed
for alarms (2999 hours).
The default VCR ALARM RECORD TIME is 002 HRS.
NOTE: If the multiplexer alarm output is not connected to the
VCRs alarm input, the VCR RECORD TIME and the VCR
ALARM RECORD TIME should be set to the same value.
When finished, press the Zoom button to go to menu 5 or
Function+Zoom to save all changes and leave the setup system.
This menu option lets you loop (pass-thru) the external alarm in-
puts to the alarm outputs.
YES  Alarm outputs represent all alarms for a particular
camera; motion alarms, mechanical alarms and video loss
alarms.
NO  Alarm outputs are for motion alarms only. External
alarms are not included (not passed-thru).
The default PASS-THRU EXTRNL ALRMS setting is YES.
Image Tenderizer