Specifications

Chapter 3  Installation 11
NOTE: Do NOT connect both S-VHS IN and VCR IN at the
same time. The multiplexer will not function properly.
Connect s-vhs in to the S-Video output (play) of an NTSC/EIA
(PAL/CCIR) compatible Super VHS video recorder. This input
is terminated.
VCR Out
NOTE: Do NOT connect both S-VHS OUT and VCR OUT at
the same time.
Connect vcr out to the composite video input (record) of an
NTSC/EIA (PAL/CCIR) compatible VCR. This output must
be terminated.
S-VHS In
S-VHS Out
NOTE: Do NOT connect both S-VHS OUT and VCR OUT at
the same time.
Connect s-vhs out to the S-Video input (record) of an NTSC/EIA
(PAL/CCIR) compatible Super VHS video recorder. This out-
put must be terminated.
Alarm
The alarms connector includes pins for mechanical or TTL/CMOS
standard alarm inputs, the alarm hold input, motion alarm out-
puts and the Autodetect VCR Speed pin. These connections al-
low the multiplexer to be completely integrated with security sys-
tems. See Chapter 6  Alarms for details.
Alarm Inputs Multiplexer alarm inputs accept a contact type or TTL/CMOS
alarm signal. Connect alarm input pins 1 through 16, to one side
of a contact type or TTL/CMOS compatible alarm device. Con-
nect the remaining side of each device to ground (post labeled
gnd on multiplexer back panel). Multiplexer alarm input polarity
is menu selectable and defaults to normally open (NO) or
TTL/CMOS active low.