Specifications
10 Video Multiplexer with Video Motion Detection
Chapter 3 Installation
Select a location for the product that is clean, dry and has AC
power. Find an environment where temperature and humidity
extremes do not exceed product specifications (see Appendix D
Technical Specifications). Failure to do so can result in equipment
failure and loss of warranty protection.
REQUIRED CONNECTIONS
Connect the video output from a camera or other composite video
source to each cam in. Multiplexer camera input impedance ter-
mination is selectable for each camera using the back panel switches
between the rows of BNC connectors. If looping through to other
equipment, set the switch to
∞∞
∞∞
∞.
Cameras 116
Main Mon
Connect main mon to the video input of an NTSC/EIA
(PAL/CCIR) compatible video monitor. This monitor displays
selected live or recorded cameras in any available format. This
output must be terminated.
Power
Connect power to the multiplexer power module or other center
positive source of 12 VDC at 1.5 Amperes.
OPTIONAL CONNECTIONS
Call Mon
Connect call mon output to the video input of an NTSC/EIA
(PAL/CCIR) compatible video monitor. This monitor displays
the selected or alarm camera in the full screen format. This out-
put must be terminated.
VCR In
NOTE: Do NOT connect both VCR IN and S-VHS IN at the
same time. The multiplexer will not function properly.
Connect vcr in to the composite video output (play) of an
NTSC/EIA (PAL/CCIR) compatible VCR. This input is
terminated.