Specifications

Chapter 6 — Alarms 37
Motion Alarm Status Table
The MOTION ALARM STATUS TABLE displays the current
day and night motion alarm option settings for each camera.
In the example below, camera 5 is set for motion alarms
between 8 a.m. and 5 p.m. for objects at least 2 targets wide
by 3 targets high. Motion alarms will not be generated for
camera 5 between 5 p.m. and 8 a.m.
The table allows you to quickly review the motion alarm
settings for the multiplexer. To view the table during normal
operation (outside the menu system), press function+down
arrow. The table appears (over the color bars) as shown below.
The MOTION ALARM STATUS TABLE has two pages. Each
page displays the Day and Night option settings of eight
cameras (01 through 08 or 09 through 16). Press call to toggle
between the pages.
The MOTION ALARM STATUS TABLE is for display only. You
cannot change multiplexer motion option settings using this
screen. To make changes, press live to exit the table and get
into the setup menu system to change settings.
Figure 8 — Motion Alarm Status Table
When a motion alarm occurs, the multiplexer alerts the operator,
displays the alarm camera, toggles TTL/CMOS and contact alarm
outputs and sends images to the VCR on a priority basis. Multiplexer
response to motion alarms is similar to mechanical alarms and
depends on whether it is in live or tape mode when the alarm occurs.