Specifications

Chapter 4 — Setup 25
SENSE (Sensitivity) The SENSE option is based on the degree of contrast between
the moving object and background for the current camera.
The motion test can help you pick the most effective SENSE
setting. It toggles as follows:
XLO — Extra low sensitivity.
LO — Low sensitivity.
MED — Medium sensitivity.
HI — High sensitivity.
XHI — Extra high sensitivity.
The default sensitivity setting is MED.
SIZE The SIZE option determines the minimum object size detected
at the current camera. You set the object size by selecting its
height and width in “targets”. For example, a 2Wx4H setting
is an object two targets wide and four targets high. A 1Wx1H
object is a single target. The largest possible object setting is
9Wx9H. A smaller object size makes motion detection more
likely, and a larger size means fewer objects will be large
enough to trigger a motion alarm.
To set the object size, use the arrow buttons to move the
flashing highlight to W (width) or H (height). Use the up and
down arrow buttons to set the value (1–9).
NOTE: To be detected, an object must trigger at least one
row and one column of targets covered by the SIZE
setting. For example, a 2Wx5H setting requires
an object to trigger at least 2 targets horizontally
and 5 targets vertically within a 2Wx5H active target
area. The object may trigger additional targets.
The default SIZE setting is 1Wx1H.