Specifications

18 Multivision® Pro Installation and Operation Manual
Menu 2 — Day/Night Start
Time
Menu 2 allows you to divide the multiplexer work day into two
independent periods, based on start times. If the start times are
the same, the day settings will be used for motion detection.
Using different start times for day and night allows you to use
different motion detection settings for each time span. Motion
alarms (ALRM) can be set either ON or OFF, and SENSE, SIZE
and DELAY settings can be different for each time as well.
To set the day start time or night start time, use the arrow but-
tons to position the flashing highlight over each character and
set it. Enter the time in HH:MM 24-hour format. In the ex-
ample below: day is from 8 a.m. to 5 p.m., and night is from 5
p.m. to 8 a.m.
DAY START TIME = 08:00
NIGHT START TIME = 17:00
NOTE: When day and night start times differ, you should
set up both motion screens for each camera.
When finished, press the zoom button to go to menu 3 or
function+zoom to save all changes and leave the menu system.
Menu 3 — Toggle Options
Menu 3 allows you to set each menu item to one of two set-
tings. To change a setting, position the highlight over it and
press the up or down arrow. The alternate setting appears.
To move to the next toggle option, press the right arrow; to
go back to the previous toggle option, press the left arrow.
The toggle options include the following:
Alarm Message Display The ALARM MESSAGE DISPLAY option controls the ALARM
or VIDLOSS graphic. It toggles as follows:
ON — The multiplexer displays the ALARM or VIDLOSS
graphic on both the main and call monitors. The
multiplexer also switches to multicamera display on the
main monitor to show all cameras with alarms.
OFF — The ALARM or VIDLOSS graphic does not display
on the main monitor, it only displays on the call monitor.
The multiplexer does not change the display on the main
monitor.
The default ALARM MESSAGE DISPLAY setting is ON.