Specifications

Products. Technology. Services. Delivered Globally.
1.800.ANIXTER • anixter.com
6.7
Video Transmission and Wireless
NVT
Video Transmission and Wireless
Transceivers;Video Powered/11880
Index1.Netw orking Systems //Video Products//Video Security Systems
NVT PR10283V2-25118.eps
Typically installed in the Wiring Closet or IDF room
, the NV-704J-PVD and
NV-716J-PVD are passive pass-through wiring devices that efficiently consolidate
camera power, video and pan/tilt/zoom data onto a minimum of 4-pair UTP
RJ45 cable. Power, video and data are converted at the camera using the
NV-218A-PVD or NV-216A-PV transceivers (power and video) which utilize a single
4-pair cable with RJ45 connectors to deliver each camera's signal.
FEATURES
• The NV-704J-PVD and NV-716J-PVD receive low-voltage camera power from any
third-party Class 2 power supply
• Control room connections are achieved with a single 4-pair RJ45 cable
(Exception: Two cables are required when all four cameras are in use and one or
more require data.)
• Control room connections may be made using the NV-413A, NV-452R, and any
passive or active NVT hub
• All equipment employs industry-standard TIA/EIA-568-
B pin-outs
Transceivers;Rack-mounting/15210
Index1.Netw orking Systems //Video Products//Video Security Systems
NVT PR21690V2-125566.eps
The NV-RM8/10 Rack Panel Kit allows for the rack mounting of up to
10 single-channel transceivers, such as NV-652R or NV-653T. Alternately, it can
support up to two 4-channel devices, such as NV-413A, NV-452R or NV-704J-PVD.
The NV-RM8/10 can reside on front or rear rails of the same rack as NVT hubs,
multiplexers, DVRs or encoders. This heavy-gauge panel is designed to withstand the
mechanical load of multiple coax cables. Threaded holes and screws (included)
provide easy product mounting and installation into a 19 in. rack.
FEATURES
• Supports up to 10 individual or two 4-channel models
• Mounting hardware included
• Standard 19 in. wide, 2U high
• Limited lifetime warranty
Transceivers;Passive/17323
Index1.N etworking Systems //Video Produc ts//Video Sec
urity Systems
NVT PR28649V2-210284.eps
The NVT models NV-215J-M (RJ45) and the NV-217J-M (RJ45) transceivers are
passive (non-amplified) devices, which allow the transmission of real-time analog
video over unshielded twisted-pair (UTP) telephone wire. "Up-the-Coax" telemetry
signals are supported when used with any other passive NVT model including NVT
passive hubs.
FEATURES
• Single-channel passive transceiver with RJ45 video-signal terminal
• No power required, built-in transient protection, supports "Up-the-Coax" type
control signal up to 750 ft.
• Transmit with another passive NVT transceiver up to 750 ft.; transmit up to
3,000 ft. if used with an DigitalEQ active receiver
• A-M = Male BNC; the NV-215J-M features a 9 in. mini-coax pigtail
• Limited lifetime warranty
341357 NV-16PS13-PVD 16-channel power supply passive
receiver hub
393093 NV-4PSRMBK Rack panel kit for 4-port power
supply products
Power-Video-Data Integrators
Anixter No. Vendor No. Description
299588 NV-704J-PVD 4-channel power-video-data
cable integrator
299589 NV-716J-PVD 16-channel power-video-data
cable integrator
Rack Panel Kit
Anixter No. Vendor No. Description
Anixter No. Vendor No. Description
368529 NV-RM8/10 Rack panel kit
Single-channel Passive Transceivers
Anixter No. Vendor No. Description
422119 NV-215J-M Single-channel passive video transceiver
(RJ45/male BNC with BNC with
mini-coax pigtail)
422120 NV-217J-M Single-channel passive video transceiver
(RJ45/male BNC)
For high-resolution applications, it is recommended that passive-to-passive
transmission distances be limited to no more than 750 ft. For distances
greater than 500 ft. always use an NVT active-receiver product.
Revise - Sec06 Video Transmission and Wireless.fm Page 7 Tuesday, December 11, 2012 11:30 PM