Operator's Manual

Operators Manual
SensorLink Sub-Gigahertz Radio Module
Page 3 of 3
Antenna integration: The antenna must be soldered to the Module, either directly or via a less than 3”
extension wire to allow placement outside of a shielded area. The antenna must not be accessible by
the end user after assembly.
DECLARATION OF CONFORMITY
TRADE NUMBER: SensorLink Corporation
MODEL NUMBER: K660-066-005, K660-066-006
COMPLIANCE TEST REPORT NUMBER: 106048
COMPLIANCE TEST REPORT DATE: 04 April 2022
RESPONSIBLE PART (IN USA): SensorLink Corporation
ADDRESS: 1360 Stonegate Way, Ferndale WA 98248 USA
TELEPHONE: [phone]
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If the unit does cause harmful interference, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving device.
• Increase the separation between the equipment and the receiver.
• Consult an experienced radio/TV technician for help.
I the undersigned, hereby declare that the equipment specified above conforms to the above
requirements.
Place: Whatcom County Signature:
Date: April 17, 2022 Full Name: Tenaya Tinsley
Position: President
SensorLink® Corporation
1360 Stonegate Way Ferndale,
WA 98248 USA
phone: [phone]
fax: [phone]
www.sensorlink.com