Operator's Manual

Operators Manual
SensorLink Sub-Gigahertz Radio Module
Page 2 of 3
Overview
The SensorLink Radio Module only approved for use in SensorLink products and has been developed for
measurement data transfer from a sensor unit to a remote monitoring device located a short distance
away.
The antenna is permanently attached and cannot be modified or removed.
The Sub-Gigahertz frequency is set to be in a non-licensed range.
The host device assemblies are controlled by SensorLink’s ISO approved revision and Approved
Manufacturer’s Parts List controlled Bills of Material.
FCC and Industry Canada Statements
This device complies with Part 15 of the FCC Rules and contains license-exempt transmitter/receiver
that complies with Innovation, Science and Economic Development Canada’s licence-exempt RSS.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and,
2. This device must accept any interference, Including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
Instructions to the User
The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate equipment
This Radio Module complies with FCC 15.249. The Radio Module must be soldered to a host board,
within the host device, which presents the 3.0VDC +/-10% regulated supply and Module configuration.
The host device must be verified to comply with the FCC part 15b requirements by a technical
assessment or evaluation to the FCC rules.
The FCC and Industry Canada statement above must be included in the host device’s User Manual.
The host device must display, visible to the end user, the text “Contains FCC ID: LM8-660066005,
Contains IC: 6462A-660066005” or similar wording that expresses the same meaning. For example:
Contains FCC ID: LM8-660066005
Contains IC: 6462A-660066005