User guide

Takeover Module Features and Operation
Digital Life User Manual | Page 47 of 62 ATT-UM-V1.1-201303
Replacing the Takeover Module (SW-ATT-TAKRF) Batteries
CAUTION: Opening the battery compartment door when the system is armed triggers
the transmission of a tamper alarm to the AT&T Digital Life Central Monitoring Center.
Therefore, in order to prevent a false alarm, please ensure that the system is disarmed
prior to opening the battery compartment door to replace the batteries.
The Takeover Module (SW-ATT-TAKRF) contains two (2) CR123A (Panasonic
®
CR123A, Duracell
®
DL123A) batteries for 24 hour battery backup. In order to replace
the batteries, first unplug the AC-to-DC adapter that is providing power to the unit from
AC power. Then remove the screw located at the top of the unit by turning the screw
counterclockwise. Be sure to keep the screw for reinstallation. Remove the front cover
on the takeover module to expose the battery compartment. Replace the two (2) old
batteries with two (2) new batteries.
NOTE: Be sure to observe the polarity of the batteries during battery replacement.
Before Battery Insertion After Battery Insertion
Replace the front cover on the Takeover Module (SW-ATT-TAKRF) making sure the
cover is firmly in place and the green LIGHT is on and visible. Reinsert the screw and
turn clockwise to tighten. Plug in the AC-to-DC adapter into an AC power outlet.
NOTE: There will be a three (3) seconds delay before the green LIGHT turns on. If the
green LIGHT continues to flash after installing the new batteries and the cover is
attached, the batteries are not good. Replace the bad batteries with good ones and
reattach the cover. The green Light will stop flashing once the cover is reattached.