User guide

Vanishing Door/Window Sensor Features and
Operation
Digital Life User Manual | Page 34 of 62 ATT-UM-V1.1-201303
Testing the Carbon Monoxide Detector (SW-ATT-CO)
See the Test Your System section for instructions concerning testing your carbon
monoxide detector(s).
Maintaining the Carbon Monoxide Detector (SW-ATT-CO)
To keep your alarm in good working order you should do the following:
• Perform a carbon monoxide detector test once a week.
• Vacuum the detector cover once a month to remove accumulated dust.
• Never use detergents or solvents to clean the alarm. Chemicals can permanently
damage or temporarily contaminate the sensor.
• Avoid spraying air fresheners, hair spray, paint, or other aerosols near the alarm.
• Do not paint the unit. Paint will seal the vents and interfere with proper sensor
operation.
• Move the carbon monoxide detector to a remote location, to prevent possible
damage or contamination of the sensor, prior to performing any of the following:
o Staining or stripping floors or furniture, painting or wall-papering.
o Using aerosols or adhesives.
• Reinstall the carbon monoxide detector as soon as possible to assure continuous
protection.
Troubleshooting the Carbon Monoxide Detector (SW-ATT-CO)
If your Carbon Monoxide Detector (SW-ATT-CO) does not power up properly or reports
low battery, check to make sure that all three (3) batteries are installed properly.