User manual

To set a Schedule rule:
1. Determine the start time for your schedule.
Check the box if you would like to add an end
time.
2. Determine if you want the schedule to repeat
during the set times and then click the
applicable days.
3. Determine the action the rule will take.
Depending on the action, you may have
additional items to select.
4. Select the arming mode the rule applies to.
5. Describe the rule.
6. C l i c k [Save].
Remember not to set up Schedule rules in this screen. Instead,
use the Thermostat Scheduler feature shown on page 19.
To set an Event rule:
1. Select a specific security zone that will trigger
the action, or select the entire system.
2. Determine what happens at the security zone
or the security system to trigger the action.
3. Select the action the rule will take. Depending
on the action, you may have additional items to
select.
4. Determine the time range and days of the week
when the rule is applicable. You can select
[Any Time] to have the rule apply whenever
the selected event occurs.
5. Select the arming mode the rule applies to.
6. Describe the rule.
7. C l i c k [Save].
To set a Non-event rule:
1. Select a specific security zone to monitor.
2. Determine the event that fails to occur during
the specified time range.
3. Determine the time/day range when the rule
is applicable.
4. Select the action the rule will take if the
specified conditions are met. Depending on the
action, you may have additional items to select.
5. Select the arming mode the rule applies to.
6. Describe the rule.
7. C l i c k [Save].
Web Access continues on next page...
1
1
2
2
3
3
4
4
5
5
6
6
1
2
3
4
5
6
7
7
22