Cut Sheet

900 Northrop Road, Wallingford, CT 06492 • 1.800.PASSIVE • FX 203.269.9621 • www.sensorswitch.com
WARRANTY: Sensor Switch warrants these products to be free of defects in manufacture and workmanship for a period
of 60 months. Sensor Switch, upon prompt notice of such defect, will, at its option, provide a Returned Material Authorization
number and repair or replace returned product.
LIMITATIONS AND EXCLUSIONS: This Warranty is in full lieu of all other representation and expressed and implied
warranties (including the implied warranties of merchantability and tness for use) and under no circumstances shall Sensor
Switch be liable for any incidental or consequential property damages or losses.
TS-WV-002A
Revised 03.20.13 © 2013 Sensor Switch
INSTALLATION
WIRING (DO NOT WIRE HOT)
COVERAGE PATTERN
SIDE VIEW
TOP VIEW
0 ft 10 20 30 40
0 m 10 20 30 40
30 20 10 0 ft 10 20 30
30 20 10 0 m 10 20 30
12.2
9.1
6
3
0 m
40
30
20
10
0 ft
0 ft
9
0 m
2.7
WIDE VIEW LENS WITH MICROPHONICS™
[R] Relay Option
[P] Photocell Option
POWER PACK
(PP20)
RED
WHT
BLK
PROGRAMMING
Refer to instruction card IC7.002 for default settings and directions on programming the sensor via the push-button.
• Small motion (e.g. hand movements) detection up to 40 ft (12.19 m).
• Large motion (e.g. walking) detection up to 70 ft (21.34 m).
• Designed for 8 to 10 ft (2.44 to 3.05 m) high mounting in room corner.
• Microphonics™ provides overlapping detection of human activity over the complete PIR coverage area. Advanced
ltering is also utilized to prevent non-occupant noises from keeping the lights on.
• Sensor has rear enclosure, which is beveled so as to be corner mounted at 8-10 ft (2.44-3.05 m); see tilt settings below.
• Mount in corner above entrance door or in a corner along the same wall as the entrance. .
• For mounting heights above 10 ft (3.05 m), use the WV BR and mount sensor to angled side to provide
an intial 30º look down.
CEILING MOUNT BRACKET (WV BR)
The WV BR Ceiling Mount Bracket allows the WV PDT 16
to be mounted in the corner of the area from the ceiling for
conditions where mounting to the wall is not possible.
SIDE VIEW
TOP VIEW
0 ft 10 20 30 40
0 m 10 20 30 40
30 20 10 0 ft 10 20 30
30 20 10 0 m 10 20 30
12.2
9.1
6
3
0 m
40
30
20
10
0 ft
0 ft
9
0 m
2.7
TILT ADJUSTMENT
Mounting Height Position
7' - 8' Vertical
8' - 9' Center
9' - 10' Forward
Above 10' Use WV BR
STANDARD WIRING
RED - Power Input (12-24 VAC/VDC)
BLACK - Common
WHITE - Occupancy State (high VDC for occupied)
PHOTOCELL/DIMMING OPTIONS (P)
BLUE - Direct output to power pack for providing
photocell control. Output is high VDC with occupancy
& low light. For multi-level control, use two power
packs and connect White wire to primary load and
Blue to daylight load.
RELAY OPTION (R)
GRAY / BROWN - Connected during occupied state
VIOLET / BROWN - Connected during
unoccupied state
Note: Relay is energized during unoccupied state
SIZE 4.7” Dia (11.94 cm)
3.3” Deep (8.38 cm)
MOUNTING
Ceiling Tile Surface
3.5” Octagon Box
Single Gang Handy Box
COLOR White