User Instructions

WIRELESSTRANSCEIVER
INSTRUCTIONS
DOC#IN-7.1
DateCode5108
1.800.PASSIVE
ADDITIONAL LED STATUS INFORMATION
• If Transceiver is in a state where port LEDs are blinking back and forth in
sequence,resetTransceiver(press and hold button for six seconds). Ifstate
remains,contactSensorSwitchTechnicalSupport.
• IfTransceiverisinastatewhereportLEDsareblinkingtogether,disconnectall
portconnection,andrepowertheunit.Ifstateremains,contactSensorSwitch
TechnicalSupport.
• When Function 6 (Display signal strength) is selected, the signal strength is
indicatedonportLEDs1+2.
• LEDswillblink1-7times,dependingonthestrengthofsignal(7isthehighest,
1isthelowest).
Numberrepresentsnumberofbuttonpresses.
*Note:HoldingbuttonforsixsecondsresetstheTransceiver
Codes are blinked on LED closest to button. Other LEDs are held solid while
indicatingstatus.
1 ToggleLEDmode
2 Searchforajoinablenetwork
3 Allowjoining
4 Disallowjoining
5 Startanewnetwork
6 Displaysignalstrength
2 Searchingforajoinablenetwork
3 Allowingjoining
4 Morethanonejoinablenetworkdetected
5 Startinganewnetwork(searchingfortheclearestchannel)
6 Lostcommunications;joiningorstartinganewwirelessnetworkisrequired
(Function2or5)
7 Armwareupdateiscurrentlyinprocess
8 Firmwareupdatefailed;contactTechSupport
BUTTON FUNCTIONS*
RADIO STATUS CODES