Cut Sheet

ManualsBrandsSensor Switch Manuals& Fan Speed ControlsWallpod Decora Wall Switch, White

Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitybrands.com/nLight

nPODMA

4 of 4

Electrical Input Ratings 15-24VDC, 5mA, Class 2 (nLight network power)

Standards/Ratings Energy Management Equipment, UL916 (E167435)

Mechanical Dimensions 2.74”H x 1.68”W x 1.63”D (70mm x 43mm x 41mm) - does not include ground strap

Mounting Single-Gang Box or Low Voltage Ring

Connection Type RJ-45 nLight Network Ports (2)

Environmental Warrantied Operating Temperature 32°F to 140°F (0°C to 60°C)

LT Option: -4°F to 140°F (-20°C to 60°C)

Relative Humidity Up to 90%, Non-Condensing

Standards/ Ratings RoHS

Security Complies with California Civil Code Title 1.81.26, Security of Connected Devices,

approved under Senate Bill No. 327 (2018)

SPECIFICATIONS

• Ensure CAT-5e cable(s) an effectively fed through the gang box

• Push the CAT5e cables through the back of the gang box

• Remove the wall plate from the device by pulling the sides out to expand the wall plate and

release it from the mounting anges.

• Access RJ-45 port(s) on the WallPod by sliding the plastic guard up

• Insert the CAT-5e cable(s) to the RJ-45 port(s)

• Slide the guard back onto metal strap

• Connect the unit to the gang box

• The unit will connect to the gang box by screws, one at the top and one at the bottom

• To ensure correct wall plate installation, drive the screws until the mounting anges

contact the wall surface. If the screws are overdriven, the mounting anges will disengage,

preventing wall plate installation. If this happens, reattach the mounting ange(s) and

install to correct position. (The anges may be reattached by inserting the two tabs in the

side of the unit and pushing the part inward to engage the three snaps.)

• Reattach the wall plate

• Expand the wall plate horizontally

• Place the wall plate onto the unit

• Contract the horizontally expanded wall plate onto the unit such that the side ange

features seat inside the wall plate

SLIDE

TO RJ-45 PORT

CAT-5

PROGRAMMING

• Refer to instruction card IN-11.3 for directions on programming the switch via the upper-most left push-button. All buttons are factory set to the matching switch channel

(button 1 - channel 1, button 2 - channel 2, etc). For nPODMA 4P DX, channels to be controlled are selected rst, then the control button (on/off or raise/lower).

• For 2L and 4L variants, the preset dim level of a button can be changed by rst adjusting the light level with either the unit’s raise/lower buttons (nPODM 4L DX) or via

another raise/lower WallPod broadcasting on the same switch channel (necessary with a nPODM 2L). Once lights are at desired level, hold a LEVEL button for 8 seconds

until the LED ashes. Levels can also be set via SensorView.

INSTALLATION

Attention! Only use non-booted CAT5e cables.