Cut Sheet

900 Northrop Road, Wallingford, CT 06492 • 1.800.PASSIVE • FX 203.269.9621 • www.sensorswitch.com
WARRANTY: Sensor Switch, Inc. warrants these products to be free of defects in manufacture and workmanship for a
period of 60 months. Sensor Switch, Inc., upon prompt notice of such defect, will, at its option, provide a Returned Material
Authorization number and repair or replace returned product.
LIMITATIONS AND EXCLUSIONS: This Warranty is in full lieu of all other representation and expressed and implied
warranties (including the implied warranties of merchantability and tness for use) and under no circumstances shall
Sensor Switch, Inc. be liable for any incidental or consequential property damages or losses.
TS-CMR-003A
Revised 10.29.2010 © 2010 Sensor Switch
INSTALLATION
WIRING (DO NOT WIRE HOT)
COVERAGE PATTERN
30 20 10 0 ft 10 20 30
9.1 6 3 0 m 3 6 9.1
0 ft
15
30
45
0 m
4.6
9.1
13.7
LOW VIEW
HIGH VIEW
0 ft
15
0 m
4.6
20 10 0 ft 10 20
6 3 0 m 3 6
6 HIGH BAY 360º LENS
• Best choice for 15 to 45 ft (4.57 to 13.72 m) mounting heights
• 15 to 20 ft (4.57 to 6.10 m) radial coverage overlaps area lit by a typical
high bay xture
• Excellent detection of large motion (e.g. walking) up to a 35 ft (10.76
m) mounting height
• Excellent detection of extra large motion (e.g. forklifts) up to a 45 ft
(13.72 m) mounting height
PROGRAMMING
Refer to instruction card IC7.001 for default settings and directions on programming the sensor via the push-button.
STANDARD WIRING
BLACK* - Line Input
BLACK* - Load Output
WHITE - Neutral
347 VAC OPTION (347)
Black wires are replaced w/ Red wires
INITIAL POWER UP
The sensor’s relay is shipped in a latched closed position so the lights
will come on upon initial power-up. If the lights do not immediately turn
on (initial installation only) the latching relay opened during shipment
and will close within 30 secs.
Note: If the sensor loses power, the internal relay will latch to on.
DIMMING OPTION (D)
VIOLET - Connect to Violet control wire from
0-10 VDC dimmable ballast
GRAY - Connect to Gray common wire from
ballast
*BLACK wires can be reversed
}
BLK
BLK
VIO (+)
WHT
GRY (-)
[D] Dimming Option
H
N
SWITCH
LOAD
PUSH BUTTON
• Sensor’s mounting holes align with a standard 3.5” octagon box or a
single gang handy box (screws not provided).
• Heat producing sources controlled by the sensor must not be in the
view pattern of the sensor. If sensor cycles or appears to continually
stay on, move sensor or mask lens segments that view the source.
• A label kit is included to mask off half of the sensor’s coverage pattern
for end of aisle, or trim the side viewing to create a rectangular pattern
for center of aisle.
CENTER OF AISLE
END OF AISLE