Manualshelf

User Manual

ManualsBrandsSensize ManualsElectronicsSensize Tracker v2 CAT-M
51525354555657585960
Table Of Contents
SARA-R4 series-AT commands manual
UBX-17003787 - R16
7Network service
Page 56 of 401
Parameter Type Description
• 18: AMR WB (23.05 kb/s)
• 19: AMR WB (23.85 kb/s)
• 255: not known or not detectable
See 3GPP TS 26.201 [91] for more details on UMTS codecs used during a voice call.
In case a set of speech codecs is assigned by the network, then the parameter
reports the lowest one and this one is not necessary the one used.
<EARFCN> Number See <EARFCN>.
<Lband> Number See <Lband>.
<ul_BW> Number Number of Uplink Resource Blocks (see 3GPP TS 36.101 Table 5.6-1 [78]), 255 if not
known or not detectable.
SARA-R4
The parameter indicates the uplink bandwidth and it is expressed in MHz.
<dl_BW> Number Number of Downlink Resource Blocks (see 3GPP TS 36.101 Table 5.6-1 [78]), 255 if not
known or not detectable.
SARA-R4
The parameter indicates the downlink bandwidth and it is expressed in MHz.
<TAC> Number See <TAC>.
<LcellId> Number See <LcellId>.
<mTmsi> Number 4 bytes MME Temporary Mobile Subscriber Identity in hexadecimal format; 0000000
0 if not known or not detectable.
<mmeGrId> Number 2 bytes MME Group Identifier in hexadecimal format; FFFF if not known or not
detectable.
<RSRP> Number See <RSRP>.
<RSRQ> Number See <RSRQ>.
<mmeCode> Number 1 byte MME Code in hexadecimal format; FF if not known or not detectable.
<Lsinr> Number E-UTRAN Signal to Interference and Noise ratio in dB.
• SARA-R410M-63B / SARA-R410M-73B / SARA-R410M-83B - The range goes from -
15,88 to 15,88; 255 if not known or not detectable.
<Lrrc> Number 4G RRC state:
• 0: null
• 1: IDLE
• 2: ATTEMPT TO CONNECT
• 3: CONNECTED
• 4: LEAVING CONNECTED STATE
• 5: ATTEMPT LEAVING E-UTRA
• 6: ATTEMPT ENTERING E-UTRA
• 255: not known or not detectable
<RI> Number Rank Indicator value; 255 if not known or not detectable. It is updated every 480 ms
with the value which has been most often reported to the network in the previous 480
ms period. See 3GPP TS 36.213 [107] section 7.2 and 3GPP TS 36.212 [108] section
5.2.2.6 for more details.
<CQI> Number Channel Quality Indicator value; 255 if not known or not detectable. It is updated
every 480 ms with the value which has been most often reported to the network in
the previous 480 ms period. See 3GPP TS 36.213 [107] section 7.2 for more details.
<avg_rsrp> Number Average value of last 10th Reference Signal Received Power (RSRP).
<totalPuschPwr> Number Mobile output power for PUSCH transmission averaged over 480 ms in dBm; 255 if
not known or not detectable.
<avgPucchPwr> Number Mobile output power for PUCCH transmission averaged over 480 ms in dBm; 255 if
not known or not detectable.
<drx> Number Discontinuous Reception "drx-Inactivity-Timer" value in ms; 0 if not known or not
detectable.
<l2w> Number SIB3 LTE to WCDMA reselection criteria: (threshServingLow)x2 +(q-RxLevMin)x2;
255 if not known or not detectable.
<volte_mode> Number Reserved for future use.
<meas_gap> Number Measurement gap configuration:
• 0: disabled
• 40: 40 ms measurement gap repetition period corresponding to the measurement
gap pattern ID 0 (see Table 8.1.2.1-1 of 3GPP TS 36.133 [83])