Manualshelf

User Manual

ManualsBrandsSensize ManualsElectronicsSensize Tracker v2 CAT-M
171172173174175176177178179180
Table Of Contents
SARA-R4 series-AT commands manual
UBX-17003787 - R16
14System features
Page 179 of 401
Parameter Type Description
integer value 42 (i.e. 0x2A) must be written as a string of two characters "2A" (IRA 50
and 65).
Factory-programmed value: empty string.
<msg_format> Number Format of the <text> parameter. Allowed values:
• 0 (factory-programmed value): text
• 1: binary
<profile_id> Number PSD profile identifier. Only the value 1 is allowed.
<IP_protocol> Number IP protocol used for socket connection. Allowed values:
• 17: UDP
<IP_addr:PORT> String IPv4 or IPv6 server address with the socket port.
Factory-programmed value: empty string.
<method> Number Notification method, it is the way the application send out the <text message>.
Allowed values:
• 1: use IP (TCP or UDP) connection
<urc_enable> Number Flag determining if the URC is to be issued or not. Allowed values:
• 0: disabled
• 1 (factory-programmed value): enabled
<result> Number Operation result. Allowed values:
• 0: success
• 1: generic fail
<bearer> Number Notification used bearer. Allowed values:
• 1: IP (TCP or UDP) connection
<nv_upd_freq> Number NVM update frequency in seconds. Valid range of 0-3600 seconds indicating how
frequently to flush the settings to NVM. A zero value indicates that settings should
never be saved to NVM, otherwise the following settings will be saved to NVM based
on the timer: <GPIO_mode>, <text>, <IP_addr:PORT>, <urc_enable>, <tx_count>.
Factory-programmed value: 60.
<tx_count> Number Indicates the number of times to transmit the last gasp message. Valid range is 1-10.
Factory-programmed value: 1.
14.10.4Notes
SARA-R4 / SARA-N4
• The <urc_enable>,<nv_upd_freq>,<tx_count> parameters will return 0, 0 and 0 if read for the first time
before setting the mandatory last gasp parameters. Once the mandatory last gasp parameters are set,
these values take on the factory-programmed values.
SARA-R410M-02B
• The command is not supported by SARA-R410M-02B-00.
14.11RING line configuration +URINGCFG
+URINGCFG
SARA-R410M-02B SARA-R410M-52B SARA-R410M-63B SARA-R410M-73B SARA-R410M-83B
SARA-R412M
Modules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full No NVM No - +CME Error
14.11.1Description
Configures the RING line of the UART interface for events such as the incoming SMS indication and incoming
data. This command is independent of the URC setting for SMS.
The RING line will be asserted when one of the configured events occurs and it remains asserted for 1 s unless
another configured event happens (in this case the 1 s timer will be started again).
14.11.2Syntax
Type Syntax Response Example
Set AT+URINGCFG=<mode> OK AT+URINGCFG=1