Manualshelf

User Manual

ManualsBrandsSensize ManualsElectronicsSensize Tracker v2 CAT-M
111112113114115116117118119120
Table Of Contents
SARA-R4 series-AT commands manual
UBX-17003787 - R16
10V24 control and V25ter
Page 112 of 401
10.12.2Syntax
Type Syntax Response Example
Set ATS4=<value> OK ATS4=10
OK
Read ATS4? <value>
OK
010
OK
10.12.3Defined values
Parameter Type Description
<value> Number Range 0 to 127. The answer to the read command is in "xxx" format. The default and
the factory-programmed value is 10 (line feed (LF, IRA5 0/10)).
10.13Command line editing character S5
S5
Modules All products
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial Yes No No - +CME Error
10.13.1Description
Sets a value representing the decimal IRA5 character recognized by the DCE as a request to delete from the
command line the immediately preceding character.
10.13.2Syntax
Type Syntax Response Example
Set ATS5=<value> OK ATS5=8
OK
Read ATS5? <value>
OK
008
OK
10.13.3Defined values
Parameter Type Description
<value> Number Range 0 to 127. The answer to the read command is in "xxx" format. The default and
the factory-programmed value is 8 (ASCII backspace (BS, IRA5 0/8)).
10.14Pause before blind dialling S6
S6
Modules All products
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial Yes No No - +CME Error
10.14.1Description
Specifies the time in seconds that the DCE waits between connecting to the line and dialling, when the dial
tone is not implemented or enabled. The command is not applicable for signal based mobile phone software.
SARA-R4 / SARA-N4
The command has no effect.
10.14.2Syntax
Type Syntax Response Example
Set ATS6=<value> OK ATS6=2
OK