User Manual

T11012920 User Manual

2. Physical Appearance

2.1. User Interface

The user interface consists of the following:

1. Three LEDs (red, green, blue)

2. One button

2.1.1. LEDs

The LEDs are intended to allow quick and easy-to-read status to be conveyed to the

end user. The user can immediately know the current status of the unit during

startup and operation.

The LEDs will turn on for five seconds due to a button press.

2.1.1.1. Status

During startup, the blue LED on the status group will blink rapidly.

Once it has completed its startup tests, the LED will indicate the

following:

Green

Registered

Blue

1 blink, Running, not registered

2 blinks, not started

4 blinks, not configured

2.1.2. Button

There is one button on the device that changes behavior based on the state the

device is in:

1. Customer Ready – this is the state the device is in when shipped to a

customer, holding the button will start the device.

2. Run – this is the state that the device is in while running, pressing the button

during this state will illuminate the LEDs for five seconds.