User's Manual

Sensitech TempTale RF
2
System Installation Manual Revision 8
Page 11
3.2. Repeater Assembly
When you receive the Repeater, carefully remove it from the shipping container and inspect for
damage, especially if the shipping packaging appears to be damaged. If you determine there has been
shipping damage, contact the carrier immediately.
Determine if 915 MHz or 868 MHz antennas are required, and attach them as indicated in the diagram
below. The 915 MHz antennas have two yellow stripes and the 868 MHz antennas have two gray
stripes.
If you attach the wrong antennas, the RF performance of the RF
2
Repeater may be degraded!
Next, connect the power supply provided at the two barrel power connector provided facing down on
the Repeater enclosure.
NOTE: YOU SHOULD ONLY USE THE 12 VDC POWER SUPPLY PROVIDED! USING ANY OTHER POWER
SUPPLY MAY DAMAGE THE REPEATER. DO NOT CONNECT THE GATEWAY POWER SUPPLY TO THE
REPEATER!