User's Manual

Sensitech TempTale RF
2
System Installation Manual Revision 8
Page 8
Next, connect the power supply provided at either of the two barrel power connectors provided. You
may need to first loosen the two thumbscrews that hold the securing plate into place. After you slide
the plate back, insert the power connector, slide the plate in place and tighten the thumbscrews.
NOTE: YOU SHOULD ONLY USE THE 12 VDC POWER SUPPLY PROVIDED! USING ANY OTHER POWER
SUPPLY MAY DAMAGE THE GATEWAY. THE SECURING PLATE IS NOT DESIGNED TO PHYSICALLY
SUPPORT THE POWER SUPPLY. DO NOT CONNECT THE REPEATER POWER SUPPLY TO THE GATEWAY!
There are additional connectors under the metal TempTale RF
2
nameplate, but they are typically not
required at installation. During installation, the plate should be left in place and only removed under the
direction of Sensitech factory personnel.