Installation Guide

Square Surface Mount Puck Light (1.25W)
1
Carefully remove LED light from square
cover
2
Screw down LED, or use adhesive pad
to affix to cabinet
3
Snap Square cover back on LED light
(proceed to step 5)
Mount for wire exiting side of LED light
1
Mark location for wire hole to be drilled
Feed lead wire through hole
2
3
Snap Square cover back on LED light
4
Sensio America
877-501-5337
www.sensioamerica.com
• Ensure that the power is disconnected prior to cleaning.
• To keep the finish of this product, wipe over with soft cloth
periodically.
• Do not use harsh chemical solvents, it may discolor or
damage the finish.
Maintenance & Care
Support
5
Run lead to driver
LED Power
Supply
Distributo
r
6
Connect driver to power
Mount for wire exiting under LED light
Screw down LED, or use adhesive pad
to affix to cabinet